Although all built-in WAL-logged modules have their own types of WAL records, there is also a generic WAL record type, which describes changes to pages in a generic way. This is useful for extensions that provide custom access methods, because they cannot register their own WAL redo routines.
The API for constructing generic WAL records is defined in
To perform a WAL-logged data update using the generic WAL record facility, follow these steps:
— start construction of a
generic WAL record for the given relation.
GenericXLogRegisterBuffer(state, buffer, flags)
register a buffer to be modified within the current generic
WAL record. This function returns a pointer to a temporary
copy of the buffer's page, where modifications should be
made. (Do not modify the buffer's contents directly.) The
third argument is a bit mask of flags applicable to the
operation. Currently the only such flag is
, which indicates
that a full-page image rather than a delta update should be
included in the WAL record. Typically this flag would be
set if the page is new or has been rewritten completely.
be repeated if the WAL-logged action needs to modify
Apply modifications to the page images obtained in the previous step.
apply the changes to the buffers and emit the generic WAL
WAL record construction can be canceled between any of the
above steps by calling
. This will discard all
changes to the page image copies.
Please note the following points when using the generic WAL record facility:
No direct modifications of buffers are allowed! All
modifications must be done in copies acquired from
In other words, code that makes generic WAL records should
for itself. However, it remains the caller's responsibility
to pin/unpin and lock/unlock the buffers at appropriate
times. Exclusive lock must be held on each target buffer
Registrations of buffers (step 2) and modifications of page images (step 3) can be mixed freely, i.e., both steps may be repeated in any sequence. Keep in mind that buffers should be registered in the same order in which locks are to be obtained on them during replay.
The maximum number of buffers that can be registered for
a generic WAL record is
. An error will be
thrown if this limit is exceeded.
Generic WAL assumes that the pages to be modified have
standard layout, and in particular that there is no useful
Since you are modifying copies of buffer pages,
start a critical section. Thus, you can safely do memory
allocation, error throwing, etc. between
. The only actual
critical section is present inside
. There is no need to
worry about calling
during an error exit,
care of marking buffers dirty and setting their LSNs. You
do not need to do this explicitly.
For unlogged relations, everything works the same except that no actual WAL record is emitted. Thus, you typically do not need to do any explicit checks for unlogged relations.
The generic WAL redo function will acquire exclusive locks to buffers in the same order as they were registered. After redoing all changes, the locks will be released in the same order.
is not specified for a registered buffer, the generic WAL
record contains a delta between the old and the new page
images. This delta is based on byte-by-byte comparison.
This is not very compact for the case of moving data within
a page, and might be improved in the future.